Search:

I have version 8 of Ezcam and wanted to see if anyone happened to have a build file for a 2007 Haas machine. Greatly appreciated if you do!

Thanks

New development ... dead and no "power" light. I'm thinking it finally gave out.

My friend didn't have one on his machine either. According to the manual it's a FR-PU01. I had the controller fault the other day when it wasn't even running. When running it looks like the spindle...

I'm adjusting the amplifier cards on a 1994 4020 (DC servos) and confused by the manual. Page 4-24 in the manual says the voltage between the SIG2 and COM (for maximum loop gain) should be 1.250 +-...

Thanks, Bill. A friend has an older 2216 that may have the same controller with the pendant. I should know by tomorrow morning if it does or not.

I recently had the cooling compressor go out, so...

There wasn't a specific fault code given.

The model is FR-320-11K-AL. I downloaded the manual for the codes, then figured out the pendant wasn't there.

One other note.... This machine was powered down for a number of years. Could the spindle have lost the parameters? I did have to replace the battery on the machine memory board and reset those...

Input voltage is good... that was my first thought.

I have noticed once in a while on start up, I get a axis fault on "C". Turning power off, and back on usually clears it.

If the spindle is...

1) Try a new cable.
2) Try lowering your baud rate. If lowering the rate works, the chips on your communication board could be getting ready to go out.
3) Send out on a different computer.

I didn't really expect this to be a stumper....

I checked the belts on both high and low range and both appear to be and operate fine. I also upped the air pressure slightly, however it does it...

My machine started throwing a new error yesterday. It's a slightly used 1994 Fadal with a Frequol Z300 spindle controller. I am doing a .02 step over finishing cut 3500 rpm and have noticed when the...

"If you are a 3 axis shop and you want the 7 new surface based tool paths that support a tapered end mill, T-cutter, Dove Mill or lollipop than you would need to upgrade to the 4 axis pro package."
...

The circulation pump is working, it is the compressor that is locked up. I found a new chiller unit for $750 on the KMAC website, but would rather just replace the compressor if I can find a new...

I was cutting and the machine suddenly started jerking, the work light started flickering, then the axis started reading erratic. Come to find out the chiller unit was causing all of this havoc. It...

What kind of accuracy would I lose by bypassing the coolant? At "normal" speeds it should be negligible considering the screw bearing is constantly being oiled with the Bijur system?

I have a couple FADAL machines and it is apparent the coolant through ball screw design doesn't work well over time. The screw itself is still good and works well, but the seals used to keep the...

That was it! Thanks Jeff!

The machine is a 1994 4020 and has been turned off for a couple years. Upon powering it on, it showed memory errors. I checked the backup battery and it needs replaced. I was able to cold start it...

I have a 1996 Fadal 6030. I am using G51.1 to mirror the x axis. In the program I use two fixture offsets. For some reason the program will not recognize the "Z" offsets, but does recognize the "X"...