Search:

Ok, I have some 6-wire unipolar motors that I've been using on a bipolar drive. I noticed under stress that the motor seemed underpowered in some cases.

Just for the heck of it, I tied the free...

These are steppers. And when I say the motors are slaved perhaps I should clarify that only one axis driver drives both motors, one through a MOSFET circuit connected to the driver output.

The...

I'm sorry if this has been addressed before, but the forum is waaaaaayyy too deep to search is such a short time!

Basically, I have a 4 ft. gantry, chain driven by two slaved motors, one on each...

Great! That did the trick for that problem. But it uncovered another problem! My axes are controlled by StepGenie ICs, similar to the 5804 chip. It runs fine under KCAM control, but Mach3 just makes...

Hello all, very first post here. Sorry it is under these circumstances! Any how, I have Mach 3 installed on a fresh install of XP Pro, service pack 3. The DRIVERTEST crashes the system completely, no...