Any luck tracking this down? I need this too
Type: Posts; User: crashman5468
Any luck tracking this down? I need this too
I'm trying to make table space for a large part on my VF-4. I purchased it with a rotary and it was on the machine when it arrived in my shop. What is a safe procedure for turning the 4th off/on in...
Yes and according to some calculations this process should eliminate almost an hour per part if I can successfully program this tool path.
I am trying to use a rough plunge process to cut a large pocket out of a thick piece of plate. Rather then pocket the entire opening, I am trying to make a series of cuts around the outer edge of the...
I have a 2.175" bore to make 6" deep in 4130 hardened to 22 rockwell. I am using a kennametal 1" diameter boring bar that is 12" OAL and I have around 8" hanging out of my tool turret. I have tried...
Its for the 4 axis horizontal machines but I'd be surprised if there's much difference!
I have a mastercam post for the moogs, let me know where and I'll email it to whoever wants it!
I have an H-30 horizontal made by Moog. The problems I encounter with my B axis are due to conection problems in the backboard of the computer. If your machine is much like mine there are large...
Hi there,
I have an HP-30 Hydrapath III. I believe your flow problem with the drip feed on your machine is a baudrate problem.
I have the 4th axis indexing horizontal machine. Is there many...
I have an ex-110 lathe with a 21i-t controller. I'm new to this machine so I'm not sure how much help I can be but a shared pool of info can always be a powerfull asset! Let me know if I can help. I...
How's it going? First post on CNCZone.com!
I have recently acquired a Taiwan Takisawa EX-110 Lathe with a Fanuc 21i-t controller. I haven't been able to figure out the tailstock programming. I...