Had you contacted LTD Engraving? Long Ha is very knowledgeable about these machines and is more than helpful. He can be reached at Tel:510-531-3053 or [email protected]
Type: Posts; User: TheBigCahoona
Had you contacted LTD Engraving? Long Ha is very knowledgeable about these machines and is more than helpful. He can be reached at Tel:510-531-3053 or [email protected]
It's been almost a year since you made your last post, so how are things going with the conversion? Can you give us an update of what you've done?
jimmieclark3 You have so much going on here. Where to begin or end. I have 3) Dahlgren System 300's 1) Dahlgren System, 1 Precix 48 x 52", a vinyl cutting machine and an old Laser machine. Been in...
jimmieclark3,
I hope you got the computer that drives the SCU (System Control Unit). The computer has a card in it that attaches to the SCU via a ribbon cable. Without that card there's no...
Good Day, Do you still have the controller and computer cards? Where are the controllers and how much are you asking for them?
I run the Dahlgren System 300's daily using AutoCAD 2015 to...
In general:
I looked up all the documentation I have and none specifies installing or testing the computer interface card.
There are two power switches on the SCU. The rear power switch on the...
This is an update 3/12/19. I'm still using my System 300 daily. I just had to replace a table linear bearing and an air seal on the spindle lift shaft. Not bad for the tens of thousands of hours on...
The person I would contact is Long Ha from LTD Engraving 510 531-3053 ltdengraving.com
Long has been repairing and servicing the Dahlgren machines for many years. He may be able to help.
sidlas, I would like to talk to you about this machine 860 653 2780 or wayne at engravers dot net
Here is a blast from the past. Do you still have the machine? If it's something your willing to sell contact me, wayne at engravers dot net
See my other post at...
Do you still have the System 300? Do you still need help? See the other http://www.cnczone.com/forums/engraving-machines/102648-software.html post for my knowledge of these engraving machines.
If...
Good day, Do you still have the System 300? See http://www.cnczone.com/forums/engraving-machines/102648-software.html for more info of my knowledge of these machines
If I can help I will.
Do...
The System 300's have different stepper motors depending on what year they were made. I run a System 300 and could use it for parts if your project doesn't work out. wayne at engravers dot net
I...
Does he want to sell it? I could use it if it's working or parts if it's not. wayne at engravers dot net
To any Dahlgren System 300 system owners... I've own and operated my System 300 since 1988/89 continuously for my business Aircraft Engravers, engravers.net. I use a 486 computer running OS/2 and...