Superman, Thanks for the suggestion. I decided to by pass the solenoid and just use a manual valve. Thanks!
Bob
Type: Posts; User: BOHICAMAN
Superman, Thanks for the suggestion. I decided to by pass the solenoid and just use a manual valve. Thanks!
Bob
Ok, Thanks!
I have a manual Bridgeport Mill. I was gifted a new coolant system which has a PLC solenoid valve. I can hook up the air lines and all. However, might any of you have any ideas on if, and how, to...
Looking for any assistance on building a .xml profile for my Sherline Lathe. As a (72 yr old) hobbyist, I have been using the Sherline Mill for several years and everything runs fine. However, I now...
Andrew,
Thanks! The steps per revolution are 400 according to Sherline. I tried the math using 400x72/360=80. When tested via G00 A360, table stopped at 180 degrees. However, I changed the "steps...
I am trying to setup Mach3 CONFIG to use a Sherline Rotary Table on a Sherline 2000 Mill. Followed what directions I could find but it's not working properly.When given the commands G00 A360 on MDI...
Feed rate is set in the G-code. Changing motors will not make a difference.
If you use CAM software, you can set feed there also. (at the beginning of a g-code program look for something like F200,...
Totally agree! I have and use both Windows/Mach3 & LinuxCNC. Dual boot system!
I have a stand alone (no internet) desktop windows 10 (1803) actually running the Sherline mill and lathe. I have another desktop, windows 10 (1803) running Mach3 (as a development machine)...