Just wondering if anyone had a general instruction to get me started on rs232 communication with this control. Mainly looking at the control side and where to get started in uploading programs.
...
Type: Posts; User: jdingus
Just wondering if anyone had a general instruction to get me started on rs232 communication with this control. Mainly looking at the control side and where to get started in uploading programs.
...
Exactly what I was looking for.
Been playing with some other variables that I think was messing me up.
Will try this out.
Thanks again
JD:rainfro:
Do you happen to know how to change the parameters so it ends up going down the center of the bore?
When you set it to helical plunge and the defaults it normally helically plunges down the...
When performing helical boring in surfcam.
i.e. taking a 2" Indexing mill and helically interpolating down the center of the
bore to rough it out. Ideally would like to do a finish pass at the...
Looking for the following part # MDS-A-V2-3520 or MDS-B-V2-3520
Dual axis servo drive on a Mitsubishi MH-500
Anyone know sources on used and or someone who can repair?
Already have price on...
Also have a tapping issue on our mitsubishi,
was wondering if you would mind sending me a copy of your post?
Thanks in advance.
[email protected]
BKCOM,
I'm interested in the procedure if you got time. I have a MELDAS 500m control and want to make sure I do a complete backup of parameters etc. What is the HR541 card? I've been using...