Search:

So the relay board is opto isolated inputs with a high/low jumper. Am I correct in saying the high would be sourcing?

Thanks Al

I have a curious situation going on..;l
I bought one of these
https://www.amazon.co.uk/gp/product/B07V4H6RF5/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

After the advice...

Have done so, I was going through the settings with just the relay coil connected, so no load on the switch side. I assumed the sink outputs block the current when not active, and act as a route to...

Dr forgive my ignorance but not sure how or what is needed for a flyback diode.. so no, I didn't add one.
Could you explain a little please?

Hi guys,
I am trying to connect a 24Vrelay to the MB2, to operate a pump on spindle start. I have configured the output y302 as a 2nd output for the spindle forward output, and the light follows...

Ok, so finally got there, it was the DCM that i was missing! thanks for your help!

Now i need to control relays to activate solenoids. I have attached a relay 24v (mb2) - A1__ A2- y302 (MB2). I...

So I stripped the wiring out, and started again... The lights on the mb2 are functioning normally, I have set of 02 pd02 both to 1..pd044 to 1.,. No action

Yes, can run with keypad.

Yes the programming all starts with PD, i think it is genuine

Regarding genuine... not sure

Yes i conneted 10~+ to the ah terminal, AL to the acm

Hi Guys,
got an issue with the correct wiring for the mb2 to my new huanyang 3kw vfd. I have been at it for 2 days now! can anyone please explain the connections between the anaspeed circuit on...

No takers? This is a one off job, but I do need it doing..

Hi guys,
this is my first post here, i have a need for a small aluminium shaft to be produced. This is a one off, a part for a camera gimbal.
Can you please have a look and i would like to get...