It is a console command like $$
https://github.com/gnea/grbl/wiki/Grbl-v1.1-Commands
Type: Posts; User: tjwal
It is a console command like $$
https://github.com/gnea/grbl/wiki/Grbl-v1.1-Commands
I think I had the same or similar problem. I could dump variables with $$, set x,y,z to 0. It would accept G commands but nothing would happen. Jogging would not change the position. I was tuning...
Did you ever figure this out?
Sid
That is the same number I found on their online store. They show about 650 in stock. Current price is $9.29
JohnW
Steve
It looks like I can get the older chip from DigiKey. I'll just have to make up a large enought order to make it worth while ordering from them.
Thanks
JohnW
One of my fav suppliers (HVWTech) shows that these chips are discontinued and are replaced by 18F4525.
It appears to be a pin for pin replacement but there are some differences that seem to add a...
With a work envelope of 2x4x8 an X2 mill would be big enough. They can be bought new for about $500. If you can find an RF30 or larger mill for a decent price, even better. There are a number of...
Hmm this must be the CNC group, what is really needed is some old technology, think blacksmithing. Make up a mandrel that matches the hole. Heat up a gear blank in your forge and drive the mandrel...
It looks similar to this one
http://www.lathes.co.uk/blowerforge/
It doesn't have the back gears which are used for very low speed cutting. It isn't that uncommon for those to be missing on a low...
It looks more like a metal turning lathe that has a wood lathe tool rest attached to it. I don't think I've ever seen a wood lathe with a prismatic way. the tailstock is also heavier than one would...
Darcy
Also check out SAIT in Calgary. One would think that NAIT and SAIt would offer identical programs but apparently there are some differences.
JohnW
Widgit
Just finished reading all the posts. Very impressive, especially the accuracy you are machining to. I'd be happy if I could consistently get 0.001"
You really need to take up metal...