ajesms offers very good post services, highly recommended.
Bill.
Type: Posts; User: cncrunner
ajesms offers very good post services, highly recommended.
Bill.
Guys, Looking only for this specific DLL file. Gibbs people won't have anything to do with me without paying maintenance.
Still looking if someone can help.
I've got goodies to trade.
Thanks.
Just looking for trades at this time.
Bump.
I have a bunch of rare compost materials I have collected over the years up for trade.
Bill.
Hi Guys,
I have Gibbscam v10.0 and Compost3 v1.3.5 KW-173. I remember reading on Gibbs online about a DLL file that works with Compost3 and Gibbscam to output a debug after posting.
...
Hi again double a-ron,
I have a similar issue a while back where gibbs was looking for a positive value, but the controller needed a negative value. In my case it was the x stock amount in the G71...
I have been learning and using Compost for a few years now. There is quite a bit to it learning what the Commands Booleans etc... mean and how to use them.
Alduns that is a good explanation of the...
Give this a try:
1. Run your finish chamfer/turning tool.
2. Run the threading cycle, no spring passes required.
3. Call the finish chamfer/turning tool back up and run it again. This will remove...
Attached is a vnc file that was created with v6.11. I opened it in v7.0 and reprocessed the one operation. The start/end of the toolpath changes. Not sure if I am doing something wrong. I would like...
Hello,
I am hoping someone can point me in the right direction-
I have been using the lathe module for a while now. I usally do not use cutter comp for lathe work, but I thought I would try it...