Does anyone have software, for the 1218 Magnaturn and is this Lathe supposed to have one or two floppy drives. I just acquired a Model 1218 with one drive, but the Owner's manual refers to two drive....
Type: Posts; User: cncnovice
Does anyone have software, for the 1218 Magnaturn and is this Lathe supposed to have one or two floppy drives. I just acquired a Model 1218 with one drive, but the Owner's manual refers to two drive....
Is anyone familiar with the Reliance Flexpak 3000 Digital DC Drive? I have been using this drive with Fanuc controller on a DeVlieg JigMill. We've increased the tach voltage to eliminate a spindle...
Has anyone ever had an overvoltage error 119 on a Haas unit? I'm using a GR-510 mill and the error suggests that my inline voltage is too high. However, my inline supply is 211VAC, my supply is rated...
PBMW...Please save you ignorance for another forum. As I suspected, someone at this "HAAS" forum could have been well informed about A FANUC controller and give some well informed suggestions. Unlike...
Please resist the urge to curse, flame, degrade, insult or embarrass someone in your post.
I'll be nice this time.
Guys,
Thanks for the help offered with my "Fanuc M-15 Spindel Stop" problem. I would have sworn that this was a software related problem because everywhere I'd searched turned up dry. After...
Al, the light normally comes on when the spindle is stopped after an M5 command or a manual stop? Right now it's doing this before the machine is homed and before any command is initiated. It's not...
I'm using a Fanuc 15-M controller to run a DeVleig Mill. Recently when I powered up the machine, before pressing the '"Machine Start" button, my "Spindle Off" lamp is lit. This was never the case...