Hello,
We recently purchased a Doosan 2100 LB with Fanuc control.
I'm not very familiar with this control yet. I wasn't sure if I'm using the q setter properly.
I'm running the Q setter on X...
Type: Posts; User: punkinbeck
Hello,
We recently purchased a Doosan 2100 LB with Fanuc control.
I'm not very familiar with this control yet. I wasn't sure if I'm using the q setter properly.
I'm running the Q setter on X...
Normally you adjust following error on the drive itself, but if it ran fine before I can't see that being an issue. Are you encoder parameters set properly?
Hello. I was hoping to get some help correcting spindle speeds on my 8050.
Theoretical RPM and actual are not matching.
I wasn't sure what parameter to adjust to fix this.
Machine has a...
Hello, I have a Toolmex lathe we just had to replace 8050 CPU on. We uploaded new parameters to the 8050.
The spindle runs but does not run at correct rpm. 1st gear the machine will only run at...
looks like i need mach 3 and sheet cam
Looking for some CAM software to operate my gecko G540. I am building a machine to profile pipe for very simple pipe saddle joints. We currently use plate and sheet professional, print templates,...
The fanuc 20t doesn't have a memory card slot on it. At least I haven't found one anywhere inside/outside the machine. I can either use a DB9 or DB25 more than likely I will use a DB9 so I can...
Okay great. Sounds like I just need to make up an adapter for a standard cable.
Hello everyone,
We just purchased a takisawa 560 lathe with a fanuc 20t control.
I don't know much about this control other than it's not very common here in the U.S. This control has a 25 pin...
thanks for the reply. I'll give him a shot
Also I am looking to cutt out just simple pipe tie ins and holes for fittings
Hello all. I am new to this forum and I hope I am posting in the right section. I am in the process of building a CNC pipe/tubing cutter. Basically one axis that goes along the length of the pipe...