It was tightened anti backlash nut
Type: Posts; User: Khomouda
It was tightened anti backlash nut
Hello friends
I made a hobby OX CNC as per openbuilds 750x750mm., I had minimal problems here and there, then I upgraded to the Chinese CHAOGE 4 axis offline controller and all good, then I bought 4...
Hi DurocShark
i am trying to get my 600w spindle to work, but i can't seem to figure it out, would you kindly help me. i dont have a VFD, just a motor PWM driver and a relay in the middle. I need to...
Nobody cares to answer me, thanks a lot
Hello friends
I am total noob to CNC and got as a hobby for drawing and little wood engraving and laser. I bought an OX CNC from AliExpress with only mechanical parts including 4 stepper motors...
Hi, I am new to the CNC world and assembled an OX CNC with Nema23 motors which were, as I thought hard to the A4988 drivers on CNC shield and Arduino UNO to handle. as I am in the middle east and it...
Dear Raphael, I really appreciate your time and help, here is a picture
Raphael, if you look at my ps pictures above you will fin the 4 wires connected to ps from the board are called 24v, gnd, 5v and L, not TH at all
regards
khaled
yes i get so I use it as in your case instead of the TH and Gnd, I have them as 5v and Gnd...yes?
I am not really intending to play with the laser input, its only the part involving the 4 wires between the board and power supply and the others that might be added between the board to control the...
no body???
Dear friends
I know that this is an old topic, but there are differences here:
First: I am a doctor which take electronics as a hobby and have no electrical background whatsoever, I got this...