Thanks again Mactec45 you're truly a massive asset to this forum and to the net.
One more good house keeping question. I'm using ring terminals on my grounds, but this vfd only has a single...
Type: Posts; User: OlmsteadWorkshop
Thanks again Mactec45 you're truly a massive asset to this forum and to the net.
One more good house keeping question. I'm using ring terminals on my grounds, but this vfd only has a single...
Received a 1.5Kw spindle in the mail today from Amazon for testing. Plugged it and it sang right away. Absolutely no issues. I'm primarily a woodworker but went with the 2.2Kw because bigger is...
Sorry that was a typo.
I corrected the wiring order out to the spindle and hooked up a new 30amp breaker and I'm getting the same result. Spins up to about 300 ROTT and shuts off with an EoAA...
Apologies that was a typo. Mostly replying from my phone.
I did correct the pin order and located the J1 jumper and tried it with no discernable difference.
This weekend I hope to test it on a...
Changed the above parameters and the below posts. I now get up to 23000 ROTT without the spindle connected. I'm not sure what the JI jumper is I may need to check the manual on that one.
Same...
Still testing on a 20amp.
When using the pot without the spindle connected ROTT will go from 7200-15952(flashing back and forth with 15969)
With the spindle connected and the pot turned all the...
Thanks for all your help Mactec54. After tweaking the settings a bit and removing the grounded drain wire I'm nearly there. I can tell it wants to go. It spins about twice as long and begins...
Thanks Mactec54. I should note I do have those two values set to 110 not 220 for my supply. I'm a bit limited on power due to it being residential, but I will remove the drain wire that is...
Greetings brand spanking new here hoping you guys might be able to help me out. I set up a new vfd and spindle using Mactec54's settings below:
Huanyang 110v 2.2Kw vfd huanyang 110v 2.2Kw WC...