It was up but now it's down again.
It's like an umbrella in Arizona, down more often than it's up.
Type: Posts; User: Antlers
It was up but now it's down again.
It's like an umbrella in Arizona, down more often than it's up.
It seems to have a high failure rate and each time it happens there is less expectation that it will be restored.
I thought David might have checked in here by now.
It looks bad.
Table '.\cbforum\smf_sessions' is marked as crashed and should be repairedTable '.\cbforum\smf_sessions' is marked as crashed and should be repaired
CamBam website down again
Yes I know now.
You have to change the "Boundary Margin" parameter, it is related to the tool diameter. Start with a number equal to tool radius then make it bigger if that is not enough.
I don't know why it is not reaching the specified depth
Does anyone know why it was down ?
Jim,
Just out of curiosity, why didn't you ask this question on the proper CamBam forum ?
I've attached a cb file that shows one way to make the item in CamBam, it was created using CamBam v1.0
It uses a variety of machining operations, spiral drill, 3D waterline, pocket, profile, all...
No, you posted a message on CamBam but didn't check back again, there is a good reply waiting for you there.