Search:

This lathe has two 8 wire stepper motors that dive the X and Z axes. The motors have a part number, manufacturer and 2.9A/phase marked on them. I have searched for the motors and the company with no...

I recently purchased this Phoenix CNC lathe. It does not have the original software and I was wondering how much trouble would it be to run Mach Turn? It has stepper motors on the X and Z axis. There...

Can other programs be used to operate these lathes?

I do not have an electrical background but is there any troubleshooting that I can do to determine where my problem lies?

I am building my first cnc router and i have read a lot of great material on here. My routeruses stepper motors and has 1 motor on the X axis, 1 on the Z axis and 2 motors on the Y axis. I am using...

What should be the power rating of these resistors?

That is the calculation that I attempted. :confused: It was difficult.

I am trying to determine the current set resistor for the G212. I have a 48V 10A unregulated power supply and I am using these motors wired bipolar parallel. These are rated at 2.8A/phase when...

I am relatively new to this forum and this is my first post.
I have been reading up on as much as possible because I am building my first CNC router. I was wondering if someone can recommend a...