Hi
I backuped a PMC file by RS232 on a Fanuc 15A series.
Is it possible to open it with Fapt ladder on my computer
Thanks
Type: Posts; User: Brunocnc28
Hi
I backuped a PMC file by RS232 on a Fanuc 15A series.
Is it possible to open it with Fapt ladder on my computer
Thanks
DID YOU SOLVE IT ?
Hi,
I need the wiring diagramm for a lathe DAINICHI F250 with Fanuc 18iTA control
Any help will be appreciate
Thanks .
[6000 séries parameters are only for serial spindle... Not supported by fanuc 0B ...
The variable resistor called position shift on your orientation pcb ( probably a20b-0008-0030 ) IS only to shift...
Option parameter IS missing.or you are not in emergency state
With ALM 3 on tour spm, and nothing else, tour fuse IS blown inside.
But i Never Saw a spm working afer fuse exchange..
Something is dead..
QUOTE=robbie0202;2554866]I have a hitachi seiki and...
I think you are talking about something on thé one you don't have any knowledge....
Fanuc 18T. Or 18iT. ?
Send pm by mail
What kind of fanuc control ?
Just let me know the number or letter you have on the seven segment display located on the master PCB
yes i have a parameter list
But if you are not familiar with fanuc, i think it will be a little bit complicated to explain all things to do by mail
You needed to set few parameters ….
Flexible gear, référence counter, cmr, not so simple….
Fanuc pmc model or Micon8 ?
UOTE=machinehop5;2515364]...possible stuck Button on wakeboard buttons[/QUOTE]
You axis card (0360 or 0390 ) ils defective
Hi,
I have an old tape Chuck with fanuc 6 control with A20B-0005-0370 on the spindle.
I have a led 3 alarm at power on .
Power supply checked, and all voltages on pcb ok .
Some ideas ?
Hi,
is there somebody who knows in the fapt conversationnal the setting or parameter to change for the language .
I bought a used machine and the fapt conversationnal is in german ...
Thanks
Hi,
you can set in place of the bubble memory a sram card witch alowed 1280 meters of memory ans it is not very expansive
Sorry for you , but it's impossible to see ladder diagram on fanus 0A , NO WAY !
Hi,
not so complicated
Need to modify PMC control using key 2 fonction
one of my customer have the same machine
please give me the exact reference wrinten on the eprom for check .
if it's the same , i can make you an offer .
regards
Are you sure about your J50L ??? It seems very strange, normaly a J300L
My machine is equiped with a fanuc 18iMB .
I loose all the data ´, includind ladder.
Is there somebody who have the same machine or à complète backup ?
Thanks