Gasp... The ATC on my VM2 is confused...or I am!
After an interference with a tall setup, and rebooting the control, I cannot get my ATC in a home condition.
The main problem is it will not...
Type: Posts; User: joe7sch
Gasp... The ATC on my VM2 is confused...or I am!
After an interference with a tall setup, and rebooting the control, I cannot get my ATC in a home condition.
The main problem is it will not...
Thanks, I would be sifting thru the manuals and parameter settings in search for the possibility of such a setting.
joe7sch
Shane,
On the hurco, if I go G92X0Y0Z0 in NC mode... will I be able to see somewhere in the control display, that the work has been shifted? I have not had the time to play and will have to stay...
I'm curious, do you use a Hurco specific post processor? I could not find a manual outlining the g-codes and cycles that are built into the NC end of the machine...
Learning curves are so much...
Gosh, tool setting also!! There must be two sets of registers...
Can't I just copy and paste the data from one to another?
I thought this machine was supposed to be user friendly...
Joe
I have been training today on a Hurco WinMax machine (VM2, I believe) and it was pointed out to me that the work position setting between conversational and NC modes is not held. I would like to...
Greetings All,
I have worked with Compost 2 in the mid 1990's
Can anyone give me an idea of the changes in Compost 3
Just the general gist of what I have missed.
And what version of Compost is...
I recently applied for a new job.
I am quite familiar with the Sabre 1000 with the 850sx control.
Can anyone tell me about the differences in the arrow 750 control beyond the graphics?
Are the...