I purchased a wire bending machine from China and then found out there is no software to convert wirefame models in CAD to the machine code. Programming every bend and angle on the console is...
Type: Posts; User: mjohnsonsa
I purchased a wire bending machine from China and then found out there is no software to convert wirefame models in CAD to the machine code. Programming every bend and angle on the console is...
I am cutting 10mm Coroplast board and not getting good results, I have tried many combinations of settings and bits but but continue to get messy edges on the vertical "fins" in the middle of the...
CNC Router Table 48" x 48" with Vacuum Table, Touchscreen & more... | eBay
CNC Router table built to industrial specifications with ballscrew precision on all axis. Less than 1-Year old. Comes...
I have a project that my CNC cannot do and am wondering if there is anyone on here with a CNC Plasma table that lives in San Antonio, TX?
Thanks,
Matt Johnson
What is the toroid primary? Is it one of the two 120v wire inputs?
About once out of every 10 times I start my CNC router the breaker trips. The reason is the inrush current from my Toroid power supply. Couple Questions:
1. Can I use a UPS (Uninterruptable Power...
This is interesting. I was told previously to keep D/C grounds separate from A/C grounds and in fact to keep D/C grounds from different power sources also separated (e.g., PC USB 5v ground separate...
I am using shielded wire between the drivers and the steppers as well as the VFD and the spindle. My question is what do I do with the shielding in the cable? Do I ground it on the sending end,...
Thank you for your response. It is this kit here: Cnc Router Kit 4 x 4 x 7 - Cnc
I am using NEMA 34 motors. The ball screw and rails are mentioned on that page.
- Matt
I am not sure how the answer to this question can be relayed verbally but I am not sure where else to turn at this point... I am at my wits end and do not know anyone locally who can come check for...