List programs did take me to the program list page. Once there, I was able to access the usb, floppy, hard drive, but it would not access the memory. It is working now. If i could turn on the macro...
Type: Posts; User: cncamo
List programs did take me to the program list page. Once there, I was able to access the usb, floppy, hard drive, but it would not access the memory. It is working now. If i could turn on the macro...
I checked it and #8 was set to off. I changed it to on and then back off again. It is working now though. I don't know how because the settings are the same as they were. Now if I could get it to...
I cannot access the memory for some reason on our VF7 and therefore unable to make simple edits to programs at the control. Any ideas?
Does anyone know how to disassemble the drawbar? I need to replace the belleville washers and I'm not sure how to get the end piece off. (this is a through spindle coolant model):mad::mad:
Does anyone have a recommendation for a good mist collector for a large bridge mill (Johnford DMC 4000)? I would like to keep the air in the shop clean and reclaim the lost coolant.
Will you be providing the material or do you need that quoted along with the machining?
Will the spindle lock after you orient the spindle with an M19? I had a similar problem on an AJV60/120 with an M-Plus controller a few years ago and had to replace the sensor for the spindle orient.
Correct. For example, if I send just a drilling program with 4-8 locations, it will work fine. Any more locations than that it will only make it so far and stops. It seems like a buffer error????
I have a Mazak AJV 60/120 with an M-Plus controller. For the past (3) years it has been giving a tape error when drip feeding from the PC, but only if the program is longer than about 10-15 blocks....
Thanks. I'll check it out.
I have loaded version 22 on my new laptop (windows Vista). everything was working fine, then it decided to go into demo mode and will not stay out of it. With the dongle not in, it says you are...
That seems to work. Thanks alot!!!
Just tried all three and still nothing.... I am using the line sketch function, is that the correct function?
I am a new user of BobCad and I need help with using the snap points. In Mastercam when I use the create line function, I can pick my start and end points by snaping to the midpoint or endpoint of a...