Hi thanks for the replies. The code is fine, so it must have something to do with my machine or mach3. If I set the hole to be 18,4mm, using mach3 as post processor in Fusion 360 and running a...
Type: Posts; User: tangi
Hi thanks for the replies. The code is fine, so it must have something to do with my machine or mach3. If I set the hole to be 18,4mm, using mach3 as post processor in Fusion 360 and running a...
Thanks for reply Zachlancy. I have tried different things now, and it doesn't help. In the meantime I also found a post on another forum from a guy who have had similar problems, mostly caused by the...
Hi
I have searched around for similar topics, have found some, but they haven't been able to help solve my problem. Besides that I hope it is to right forum to ask in, if not I apologize.
My...
YEEEES! It worked, it is working so nicely now! Thank you all for your inputs. The setup is now as follow:
PoKeys57CNC
3 * NEMA 23 - 0.7Nm - 1/4" shaft (1=Z, 2=Y)
NEMA 23 - 1.3Nm - 1/4" shaft...
Okay cool, and thanks for a fast reply. If ebay it has to be an european one, I live in Europe and I see that stepper online ships from within europe, so it shouldn't be a problem with them :)
Okay thanks for the reply rodw, it seems that I must upgrade my drivers, to get full performance then.
I been looking around. Would something like this be good for a setup like mine?
...
Yes, it does say on the driver printboard max 40V, but yeah in the manual 30V. But I am thinking of changing the PSU to 36V, but then turn it down to maybe around 28V. Does that sound as a good idea?
I have been searching a bit more. I thought that maybe my wiring could have something to do with it. My drivers are wired in parallel and not serial, can this maybe have an effect that causes the...
Thank you very much for the chart wmgeorge. I am not smart enough neither to figure it out. The Y-axis is set to a very low velocity in Mach3 to have some torque and is running as I remember 1/8...
Ok so I should try to switch PSU to maybe a 36V? This is what info I have about the motors
https://ibb.co/7CycQ6r
The size is 1000m * 750mm
Up to 2A for the three small motors and up to 2.8A for the large motor
I have not connected any relays to the setup, I think it must be the PSU? But I really don't...
Hi all
I have this setup
PoKeys57CNC
3 * NEMA 23 - 0.7Nm - 1/4" shaft (1=Z, 2=Y)
NEMA 23 - 1.3Nm - 1/4" shaft (X)
Power Supply - 24V 10A (Noname)
Stepper Driver 2.5A - PoStep25-32
Ahh cool, it was my plan too to upgrade it with a lathe. But thought that one pokeys57cnc would be enough for that, because it supports up to 8 motors? My cnc is running now, but for it to be strong,...
How big a power supply do you have for your drives?
Sendt fra min A0001 med Tapatalk
Hi, not to any help, but saw that we have the same controller, but what setup do you have? How big a power supply and which stepper motors? I have a Pokeys57cnc too, but with the smaller postep25-30...
Hello everyone.
I found this forum because I am in the middle of building a hobby cnc machine for woodworking. I could use some help with electronics etc. It is running now, but I struggle to get...