I apologise for not responding recently. I have had a graduation and I am remodeling a shower. I should be able to get back to this in the near future. Don't give up on me yet.
Thanks for all your...
Type: Posts; User: K_Schulz
I apologise for not responding recently. I have had a graduation and I am remodeling a shower. I should be able to get back to this in the near future. Don't give up on me yet.
Thanks for all your...
I am using a laptop without an Ethernet connection. I purchased the uc100 device from the seller's recommendation. The seller is now telling me about a smooth stepper device. Again, I am using a Dell...
The information provided to me was more of installation documents without specifications. The pictures show the only markings on the spindle and the other picture shows the writing on the power...
Some pictures of the system. I don't think the wiring is...
I did install the EMI filter on the power input to the vfd. I also install ferrite chokes on the wire from the computer to the uc100, the other input and output at vfd, and power wiring. I did put a...
Thanks for you help the ferrite chokes and EMI Powe filter seems to be helping. I appreciate you taking the time for my problem.
Sent from my moto g(6) using Tapatalk
There are several types of EMI filters to select from. What would be the requirements and does this get installed outside the enclosure or inside? I will install the snap-on ferrite pieces on each...
The cable is about 3'. It is the cable that came with the UC100 unit.
Sent from my moto g(6) using Tapatalk
Here are a couple pictureshttps://uploads.tapatalk-cdn.com/20200616/f0f1207b7709394dc83ed0f03139ba90.jpghttps://uploads.tapatalk-cdn.com/20200616/d50d0711304eb82811b6c16ecf8a8315.jpg
Sent from my...
The manufacturer is Industrial CNC, 4x8 with 220V supplied. There is a VFD. I will send pictures later today.
Sent from my moto g(6) using Tapatalk
Ok, thanks for the response. I didn't want to remove the limit switches but it seemed worth a try. I would like to get this machine operating correctly. After I check over the connections that I did...
I have an Industrial CNC machine with Mach3 controls through a UC-100 USB adapter. I run through Dell laptop (16 Gb Ram, i7 processor). I am having issues with tripping limit switches and the...