Sure hoping someone can help. I have a Tsugami NP20 that had to have the Sub CPU board replaced. I downloaded the Parameter for the Fanuc Controls and the Diagnostic Code (What is now the ladder)...
Type: Posts; User: Thrasher
Sure hoping someone can help. I have a Tsugami NP20 that had to have the Sub CPU board replaced. I downloaded the Parameter for the Fanuc Controls and the Diagnostic Code (What is now the ladder)...
I have a Tsugami NP20 showing Error Code 1100 "SUB CPU ALARM" and 550 "OVER TRAVEL :+5" I have checked the over travel switches and they seem to be fine. The machine is not in an over travel...
Good Morning. You may be confusing a tool database with machine tool cribs. The tools you build via Solidworks or some other CAD program can be put in your tool database and will go into order...
I have a Pehaka 360ZP that has lost it program. It appears the menu is still in tact and I should be able to reload the program from an on-board ROM memory chip. I had success in doing this many...
You can change this by going to TOOLS.... OPTIONS.... DOCUMENT PROPERTIES..... UNITS
Tsugami Man.... Thanks for the reply.... any idea where I can get some measurements so I can fab up the needed parts? Also, do you know the M Code that fires the air blast. Found the line that...
I have purchased a Tsugami NP20C and the mechanismthat attaches to the sub-spindle so a completed part can be ejected into the parts catcher is missing. Not sure what it looks like.... assume it is...
If I were you.... I would make an investment in a sweep gauge. May save you a lot of problems. And get rid of the electronic edge finder. Not very accurate!! Nothing beats a .0001" dial or...
I heard someone ask a friend of mine one time: "What is the key to successful business?" My friend without a minute of hesitation said: "years of losing money." It takes a lifetime to learn "All"...
I do have a set of parameters for an OSP 5000. What kind of machine is your control on? My parameters are for and Okuma MC-40H
I am getting alarm: AL24 Axis Interlock On a Fanuc 16M Controller. Not sure what to do to get the machine out of this condition. X and Y move fine. B and Z won't move. I was working on the...
Which side is this on.... Okuma-Howa or Fanuc?
Our machines run several different programs and we change the work offset many, many times within a given program. I guess my question would be: Why not use the G10 as much as needed. With good...
Another thought.... it does have a high and low range, but this is all handled inside the Vector Drive unit. I had the drive go out once.. replaced it... fixed the high-low issue.
I have an SL-20.... No transmission. Belt drive from motor to spindle.