Search:

Thanks in advance for your response.

I have a Fanuc 18MA that I drip-feed via RS232. I have done this for many years with minimal issues.
The only problem I have is when a tool change is...

I know this is extremely old... but what did you ever come up with. I am having the same issue. Thanks.

I have a Fanuc 18M controlled VMC that I have been chasing a trail of damaged components that I believe was caused by a grid power surge or spike, due to not only this machine but another machine and...

I need a manual for a GMF Robotics S-200 controller for a Fanuc Robot.

I'm having an issue mastering/calibrating the unit.
I purchased this robotic arm and controller a couple years ago, and...

Machine:
2004 Fryer MC-60 VMC with Anilam 6000 touch Controller

Symptom:
The Y axis loses about .020" after making a single circle interpolation.

Frequency of Issue:
I ran a large test...

SOLVED:

Servo Amp_______Servo Motor
U(UM)..................Pin 1 (Red)
V(VM)..................Pin 2 (White)
W(WM)................Pin 3 (Black)
G(GM)..................Pin 4 (Green)...

I need to know which wires from the servo amp goes to each pin on a Fanuc servo motor ( A06B-0373-B571#7008 ). The 6 wires were pulled/ripped out of the wire connector on the motor after a drastic...

What did you find out ?

A little more info: Last week on 10/14 I installed a repaired power supply by Tri Star CNC. the machine was working fine, but looking back in the Alarm History, since the power supply was...

PS. Each axis moves in the ( + ) direction when they are selected. I can move each axis in both directions using MPG.

My Gantry Mill with Fanuc 18m Controls was working fine yesterday morning. Now it is as if the ( + ) key is enabled and will not disengage. I've hard reset the machine numerous times, and checked...

I mistyped twice.... I meant SERVO AMPLIFIER not servo alarm.

After replacing the power supply and having a servo alarm repaired. I now get the following errors on my Mill ( Fanuc 18M system ).

410 - Servo Alarm Z Axis Excess Err
410 - Servo Alarm Y Axis...

Thanks for the replies. I downloaded the software from cadem.com, it's a simple send and receive program. Exactly what I was looking for. And free.

Thanks Again.

What is the best communication software for a Fanuc 18m system ?

I have this exact problem, though with a A16B-2201-0080 board. I had an issue with the Power Supply, and replaced it. Then a couple days later received this error and CRT will not power on. Prior...