Search:

Hi
Our CNC uses a 1 pump 4 zone system for hold down. Even with rear zones closed I am not getting enough vacuum to hold down 1/8" PVC, pieces being cut are 4.5" x 14". They seem to have less vacuum...

Hi
Onsrud 66-092 on 1/8" thick HDF

Thanks
Greg

Hi
Experimenting with 1/8" HDF. Onsrud gave some help with bit selection but I am still trying to dial in my feeds and speeds to get a clean edge with no "fuzz". Any ideas are appreciated. Thank...

Tested multiple mm/pulse values and 0.0122 on X and Y work on manual tests and file tests. hopefully smooth sailing from here.
Thanks to all for your help.

Greg

Ran further tests today. In the ArtCAM software I made a square 100mm and a circle 100mm dia = both files simulated correctly but when run they were 95mm



Doing a manual test on router - X axis...

Hi
This forum seems very helpful. I fired up our new SUKE 1325 CNC Router for first time today. Upon launching NC Studio (ver 5.5.60) I was greeted with errors. BKREF ESTOP LIMIT ALARM. I went...