I have a 2000 Bridgeport VMC 3016 that has a non functioning 4th axis. I've been working on the unit and have come to conclude the biggest problem I'm facing is with the cable assembly. The 4th axis...
Type: Posts; User: P-J-M
I have a 2000 Bridgeport VMC 3016 that has a non functioning 4th axis. I've been working on the unit and have come to conclude the biggest problem I'm facing is with the cable assembly. The 4th axis...
I have a 1989 Mori Seiki SL-15 with a Fanuc 10T control. Had to have the spindle servo control repaired, afterwards had to reload parameters. That's where the fun starts...
In the Handy Settings...
Are these corrections I can make? Or do I need to bring in a tech?
I think I'm 90% there (or better). I basically had to clear memory and start by reloading the 9XXX series parameters in hexadecimal format. The continuing problem is PC/NC parameters, namely the Data...
There isn't a KEEPR 17 bit to change. Only goes K0 to K14.
I think I'm 90% there (or better). I basically had to clear memory and start by reloading the 9XXX series parameters in hexadecimal format. The continuing problem is PC/NC parameters, namely the Data...
I think I'm 90% there (or better). I basically had to clear memory and start by reloading the 9XXX series parameters in hexadecimal format. The continuing problem is PC/NC parameters, namely the Data...
Am able to access all the pages of the Data Table Settings parameters (there's a lot of them), but the 2 I need to set are not included. Is there a way to add these 2 parameters to the table?
I needed to use the IPL screen to load the 9XXX series parameters, then went back and loaded the rest. They're all in now but machine will not move and states ZRN required in both axis. Can't even...