Search:

I recently 4 Stepperonline kits including: 4 1699oz. Closed loops motors with CL86Y drivers. I am using a PMDX-411 for my controller. It is attached to my PMDX-122 Breakout board. I am using Mach4...

Thanks, I hope someone sees this so I can find out how it is done. I will post a new thread if I do not get info. I did find out that I am using Mach 3 and not Mach 4 since Mach 4 is not out...

The R&P are a ratio of about 3:1, I will get more specific later(at work right now). I am using 1200 oz. Servo motors for the X and Y Axis. 400 oz. for the Z Axis. I will get more info tonight. ...

And it is problematic on smalll budgets

I will get some pics up here

Thanks

Yes, that is what I am doing now, sorry about the mis-understanding

Thanks, I am not sure what you mean about carrying a drive shaft across the table however

Thanks all for the information I will research it all

I built my CNC Router about 3 years ago, and it works quite well, but as funds came slowly I opted for a Rack and Pinion system instead of Ball Screw, big mistake. It is virtually impossible too...

Thank you I have already oredered from Duramill. Great place thank you very much. I am not sure I can run at 100ipm but probably 50 anyway. My machine is quite rigid. Thanks again

Thank you this helps alot

I just finished biulding my first Router. I have a Servo system from Camtronics with 1100oz x-y axis and 400oz for Z. I need to make aluminum parts out of 1/16" 6061 Aluminum. I purchased a Porter...