Search:

This is a pretty slick solution:
Supersoft Jaw Tips « Milling Around

I had the exact same problem last summer, I found that the little clamp holding the right tube in place at the top of the head was indexed ~45 degrees and was pressing on the tube itself. I...

I thought i saw an estimated price at some point but cannot locate. Does anyone have any idea of what this cool add-on would cost?

Thanks, Jason

The other post above is an awesome setup which i copied myself. this was after several a couple of failed atempts at purchasing 1/4" & 1/2" locline fittings, neither of which fit the stuff that...

No doubt 3 problems in a row is a bummer. I have ordered many times from them and my shipment has always been spot on. I dont know if you are working with Ann but she has lways been very helpful to...

Absolutely agree, very classy.

Jason

I was trying to be funny but failed, i use G-Wizard sometimes and like it.

But now i've run into another problem, I was thinking about the FM-45 as mentioned above but ended up going with the...

If only there was a program that could calculate HP required and recommend depth of cuts... :rolleyes:

It arrived today. This shell mill is awesome. Its a pretty big hunk of metal and don't think it would be much of a challenge to stall the little PCNC using this. Now that I see how big it is i...

Masterfully done.

Good looking mod Don. Any concerns with the circlip taking the load put on it from the draw bar? I always pictured that as being close to 1,000 lbs.

Jason

Thanks guys, was hoping Glacern had a straight shank option but all is see is R8 and its out of stock, wonder how quality the Enco piece is.

Jason

Hey guys, is there a TTS holder for the Glacern FM45-400 Cutter?

Link - http://www.glacern.com/fm45

Thanks, Jason

That is too awesome. the fact that it takes up 1/3 of the garage shows you have your prorities straight!

Jason