Search:

i just got all the electrical wiring in the cabinet done over the weekend. the servo parameter still need a little more tuning. here is a video of the first test run. YouTube- Bridgeport v2e3_0001.wmv

hey sparky, what is you driver setting set at. i play with my driver setting, but keep getting-- running fault--servo limit reach-- error output.
i have solve the encoder problem, it was a bad...

just got another pin out for the boss 8 encoder from ajax web site. the wiring diagram does not work either. the led 3 on the servo keep flashing red. :confused:

i got one drive wire and power up. the led 3 keep blinking and it would not connect to the turning software. read the manual and it show that there is something wrong with encoder. anyone have a...

i bought 4 drive and get free shipping with it. i get all the electrical cabinet move today. I'm reusing the rear cabinet with the main disconnect. the servo power block / cap move under the...

i just got my dugong drive today. i am going to rip out old servo and installing the new dogung drive this weekend. time to upgrade my v2e3. hey sparky, what size braking resistor did you use for the...

my v2e3 just make me mad today. it would not cut circle or an arc correctly. i try to cut 2 inches diameter circle and the machine cut a figure 8 with a line in the middle. i try using I-J and Radius...

Great job on the retrofit Sparky_NY. i am looking to do a retrofit like your in the future. right now i am still trying to find an electrical schematic for the controller.

anyone you you guys...

[QUOTE=CNCISME;692142]Sparky my S/N is 193

hi CNCISME, the v2e3 mill from michigan that you mention. did you talk to a man name BOB MURPHY. i recently bought a v2e3 from BOB MURPHY in Saginaw...

i change the G91 to G90 and it work. i'm so happy and ready to cut some parts. i like to gave a big thank you to all you guys:cheers: that help me out.

i'm running P4 2.4GHZ 1.7GB RAM. zip file attach, hope you guys can see it.

if i cut the file down to 1000 line, it would work fine. the problem is that i want to make a small jello and cookie mold and need to run all the code at once. separating it would take a lot of time...

I'm currently have a big problem with EMC2 not reading a large G code file generated by art cam. i have try difference file extension from art cam and none of them work on EMC2. small file of 3000...

i will try to play with the setup config ini file again tomorrow, the weather is too cold to play around in the shop. now my z axis home switch stop working, no respond at all even when i change to a...

i am trying to put 3 home switch xyz on my gantry router and use emc2 to setup the home position. i have install the switch with a pull up resistor and everything. my problem is that when i home the...

pacific scientific 1.8 degree step motor
model: H33NRHC-LNN-NS-00
ls(dc): 11.1 A bipolar parallel
vs(dc): 35 v
po: 101 w
W: 1500 rpm
ambient: 40 degree C
^t: 90 degree C max
5 wire( black,...