We have 2 Mori Seiki ZL-25s with the MSC-516 control. We are using the tool life management on these machines. The problem is that one of the machines does not stop the machine from running once...
Type: Posts; User: koolaidkid
We have 2 Mori Seiki ZL-25s with the MSC-516 control. We are using the tool life management on these machines. The problem is that one of the machines does not stop the machine from running once...
I am getting an occasional 185 a cable fault alarm. Typically we can hit reset and clear the alarm and are able to run again. Sometimes it runs for hours without this alarm, sometimes it happens a...
I haven't used the milling units in years, so I haven't needed to try and find new ones.
Found a shop out east that had a machine very similar to ours and they were kind enough to download their parameters for me.
The only thing that isn't working is the machine used to go into...
We had to reset our entire fanuc control (16T) due to a ram parity alarm and reload the parameters. I had the NC parameters, but I need the PMC parameters as they contain timer settings and I don't...
Thank you all for the help, I forgot to reply. Found that we had a bad o-ring in the valve for the precharge that was allowing air to flow all the time. Found a valve at a local (non-haas)...
I am having a similar issue to the original poster. The drawbar is clamping slowly the last .250", sometimes not far enough to engage the clamp switch. I took off the precharge line and it snaps...