Search:

has anybody upgraded to windows 10 using torchmate 4 and torchmate cad 8? according to torchmate it "should" be compatable but has anyone actually tried?

make sure your limit sensors are working and set properly

For me, I use 100A consumables for 1/4" and thicker steel. 1/4" i have the speed at 130 and voltage at 150. The speed and voltage tests were just a starting point when I was figuring everything out...

What exactly do you mean it is not following the tool path correctly? Are you exporting from Torchmate CAD as a .dxf (Polyarc). I was told by Torchmate that is what is recommended.

Make sure your speed and voltage are set properly and make sure your consumables aren't worn out.

I think you mean "edge start". That just means your lead-in is on the very edge of your steel rather than piercing a hole. I have had success with piercing 3/4" but I would avoid it it you have the...

Does anybody know of good gcode software besides torchmate CAD? I don't need drawing software since I have a real CAD program, just one that converts the drawing into the gcode for cutting. Thanks

What do you mean "inverted"? Is it cutting out the parts mirrored from what the software shows?
Did you draw them with Torchmate CAD?
Are you using the correct tool path? (ie. male for shapes &...

How thick are you talking about? I have had no problems piercing up to 3/4" mild steel with very little problems.

My company has a Torchmate X Water Table. My lead-screw (and nut) have worn out and has been replaced with one I ordered direct from Torchmate. Does anybody know where I can find one elsewhere that...