main program
from the G54 line,PRORAM L20
N40 G00 G90 G54 X-1.0 Y0.0,
N50 G43 Z2.0 H01 M04 S2000,
N60 M08,
N70 G01 Z0.11 F200.0,
N75 G22 L2222 P41,
N80 G00 G90 Z2.0 M09,
,
,
Type: Posts; User: krow
main program
from the G54 line,PRORAM L20
N40 G00 G90 G54 X-1.0 Y0.0,
N50 G43 Z2.0 H01 M04 S2000,
N60 M08,
N70 G01 Z0.11 F200.0,
N75 G22 L2222 P41,
N80 G00 G90 Z2.0 M09,
,
,
Yes I do have a g23 in there and it reads the sub fine but it just doesnt repeat.I am at work right know and tring everything I can
thanks I keep trying
I am running a okk mcv500 with a meldas 50002-c control.I cannot get the P to repeat a subprogram for me, it just runs thru the sub once and returns back home.Maybe a parameter is not turned on???
...
I tried the program but it still does not work.I even checked in the programming book and it says the same thing as you.When I run the progam it only does it one time then returns home.Any more...
when I went to the site,they only had a 5000c verson.I figured out the machine and some cycles,but I am having trouble with my subprograms.I can't make it repeat the cycle eg.40 times,without putting...
A main board that feeds the monitor,located in back of the machine.It was faulty or worn out.
hey
I checked the voltage up to the input unit board and the voltage was around 220v.I am not sure if thats were you check.There is no voltage going up to the power unit until the machine starts up...
THANKS
FOR THE HELP
Thanks for the info,not sure what caps are though.Please explain.
hey,
Starting to have problems with a 1985 OKK V.M.C. with a FUNUC 11M control.The machine won't start up right away especially on mondays,after sitting for a long time not powered up.When I press...
Thanks
I will go and check it out.
Hey,
For milling centers with FUNUC controls, I always used G83 or G73 Zyour depth R your distance above + or below- your work Q is your peck amount and F is your feed.I never seen IJK before with...
hey,
I am running a okk(model mcv-800)with a okk-cnc matic 2(mitsubishi cnc meldas-5000c2).numerical control.
Not sure how to start the program, I am use to a funuc controls.It would be great to...
Thanks , didn't realize that.Don't want to upset anyone.I'll end this thread here
The mill is called a KAFO,and it is not a doosan or a daewoo mill.Just thought somebody would know the controller.Anyways when I program it to do a thread,it just stays on the one z plain.It does...
end
hello,
need step by step instructions on how to realine a turret,with tapered pins for a 2004 puma 300c.
thanks
thanks, i'll defineatly give it a look over.
hello,
I just started today.I am having trouble with the a puma.Most of the time when i take a cut on a bore ,that is no running true(cut 0.15 thou. per side)the turret shakes and vibrates the whole...