Search:

Hello,

I added a Tsudakoma RZ-160 rotary table to a Fanuc Robodrill alpha T10C from 1996 vintage with a 16m-c controller on it. I converted the tsudakoma to an alpha a1/3000 servo and paired it to...

Thank you Seikiman and machine hop5.

I have solved this and learned a bit. After speaking with Fanuc about replacing the hard drive they tipped me off that the EPROM(s) on the data server that I...

Hello,

I am adding a 4th axis to 1996 Fanuc Robodrill T10C with a 16mc and I have a question - the parts manual states I should run two wires from the d-cell battery box on the cab door to CP5 on...

Hi Tonper, did you figure out how to clone this drive? Any chance you could send me the clone image from your drive? My hard drive crashed in my Fanuc data server and am looking to work with a clone...

I am not sure exactly when they started doing it (t10A might be on the edge), but Fanuc stores all of the parameters of the machine into a permanent section of memory. start the machine up and press...

G05 P10000 is HPCC (High-precision contour control) and that comes with a massive amount of parameters. Your machine may be tuned a certain way to slow down before reaching an arc/curve of a certain...

I believe parameter 7815 sets the actual rotation of the turret. My machine is older and my tools are big and crazy at times so I slowed it to 800 I believe.

Power on the machine, press the quick NC button. Under maintenance soft key there are options to adjust how the machine turns on. To what screen its starts up in, rapids, etc. Change the settings...

Hello,

I have a 1996 T10C Robodrill with a 16M Fanuc Controller of which I've installed a Fanuc data server (A16B-2202-0630) with an original 256mb Quantum Daytona IDE hard drive (A02B-0207-CD51)...