Thanks for the quick replies.
Bob
Type: Posts; User: CT Bob
Thanks for the quick replies.
Bob
On the shielded cable between VFD & spindle do you
attach the drain wire to VFD ground & spindle ?
Thanks
Bob
Setting up new router.
1605 screw on Z
1610screw on X
2505 screw on Y
When setting steps per inch in motor tuning for 2505 screw to 10160 it moves 2xMDI input.
Axis Calibration will change...
I did not realize how easy it was to take apart.
I swaped the A & Z axis.
Left the bad drive out, will try to return for repair when i get
everything up and running. I might screw up something...
Ian thanks for the promp reply. Yes i am useing the xlm from the Gecko site. In process of bench testing
everything.
Bob
G540 Rev 5 and Mach3 new setup.
I stripped Z axis trimpot.
How do I swap with A axis. do i have to physically change drives or just software settings.
Thanks
Bob
How flat are the aluminum plates for table top ?
Bob
Has anyone tried cutting alum with a 1.5 HP Colombo.
Small cuts