Hello,
My DROs are blinking..... x,y, and z blink, and when it does the position jumps to somewhere else....the position stays the same during the "blink" unless I move the coordinates. When I...
Type: Posts; User: andybwells
Hello,
My DROs are blinking..... x,y, and z blink, and when it does the position jumps to somewhere else....the position stays the same during the "blink" unless I move the coordinates. When I...
Thanks again!
Hello! I have my CNC setup and I am having trouble with the control of it. If I use the VFD device I can control the RPM of the spindle with no problem. When I set it up to be controlled by Mach3 for...
Dude....you are a god send....I recently moved the table and had to disconnect the wires...when I put the wires back on the is motor one of the wires went under the metal clamp and was just on...
Hello,
I had a working cnc and everything was fine. My controller burned out so I got a new one and that fixed the problem. I replaced my controller with the identical controller. I am using all...
Can you recommend a good controller?
Hello, I have a slave problem posted here: https://www.cnczone.com/forums/mach-software-artsoft-software-/426244-cnc-software.html
I am wondering if I just connect both motors to the Y axis from...
Hi Dean448, yes I connected my A wires to the Y connector on the control board and ruled out all wire or motor issues. The A wires and motor work just fine when plugged into any other axis on the...
Hello,
I am new to cnc and I recently purchased a workbee 1500x1500 setup from bulkman3d...after painstakingly setting it up and building the framing and wiring all the electronics I finally was...
Hello,
I am new to cnc and I got and built my first setup 1500x1500 bulkman3d workbee. I have the Digital dream UC300 controller.
Everything was working fine until the other day when I had a...