Hi There,
Does anyone have a sample program for the above mentioned barfeeder? I have it working on single bars no problem but don't have a sample program to set up the bar change. I think it uses...
Type: Posts; User: cncmedcom
Hi There,
Does anyone have a sample program for the above mentioned barfeeder? I have it working on single bars no problem but don't have a sample program to set up the bar change. I think it uses...
Thanks. Here is attachment of the cable which I was after. Hope this helps anyone else with same issue.
Hi all,
I am looking for the pin configuration for my Mori Seiki NL2500SY. Control is the MS850 which is Mitsubishi 700BM (machine is 2007). I am running a 9 pin female to 25 pin male using com...
Hi all,
I am having trouble with my Sodick A320D with EX21 control. On firing up the machine I get an error flashing "H004 DATA FILE IS NOT FOUND IN DRIVE 2, SET THE DISK AND PUSH ENT".
I reset...
Thank You Larswebb,
I will give this a go and let you know if it works. It is a different RS232 cable configuration to what I am currently using so fingers crossed. :)
Hi all,
This is the first post and probably the first of many as I have just obtained a Sodick A320D with EX21 control.
The floppy drive is no longer working on my machine and I need to use...
i get mine from usa and shipped to australia it is stress releived and centreless ground and you wouldn't beleive the difference. try boston centreless it has the best quality stainless steel ground...
F and L series. wish there was the tooling and centreless ground annealed material that is available in the US it would make sliding head turning a lot less stressful.
Hi cnc hammer. I run a small shop using citizen lathes. I have ran them for the past 6 years and have found that service for them is very poor. A local Mazak dealer has the agency and has previously...
cnc turning up to 16mm dia. fast lead times. small quantities acceptable. Good prices.:)
Just worked out cycle time display on 3t control. Parameter 997 should be 01010000. while trying to fix a different problem i found this. Dumb luck is a great thing!:)
thanks for the reply. I checked all parameters and they were fine. After hours of frustrating tests i noticed that the previouse machine owner had replaced one of the trip switches with a very...
hi, i was wondering if anyone could help me. I have a fanuc 3t control and my coolant pump cable was sheared off and two wires crossed resulting in an alarm. I checked all fuses that i could find and...
what are the quantities and material specs. This will need to be checked with non contact measurement equiptment. Part is too small and soft to perform second operation to remove burrs if they are...
thanks al i will give that a go today. i think i have some new brushes there so i will clean out the servo and replace them.
I also work on citizen swiss machines we have 16 of them and i have the same problem. The programming is so far from the generic post that it is almost impossible to modify. i am working on writing a...
This alarm usually happens when i power up in the morning on an old citizen sliding head machine. I know its and old machine and shouldn't still be in service but it is still unbelievably accurate so...
hi everyone,
i was wondering if anyone can help me with mastercam peck cycles. I wish to change the post so the dwell occurs after the drill rapids out instead of at the bottom of the hole. i have a...
just new to cnc zone this is my first post. I have a few citizen machines with 3tc controls i will mail you the parameters. Also i was wondering if anyone knows which parameter i change to view the...