Search:

Could it be something with the servo indexer and refresh rate? It cuts to nice tight tolerances, but maybe just when it runs the tool measuring sub-program the contoller program loses track of where...

I see that people keep looking at this post but no replies yet. I'll throw out a few ideas I've had over the last few days here and hopefully someone will tell me if I'm heading in the right...

I think a syringe-type dispensation would be more accurate if the paste came out horizontally rather than vertically onto the pad. An L shaped nozzle with a square opening would give you a good...

It depends on the components of the circuitry, TTL components are less common in CNC machines because any voltage over +/-5V will most likely toast them. CMOS components are heartier (+/-12V) and as...

If your shop isn't bigger than 50 employees investing in ERP would be a freaking NIGHTMARE for you! Remember...KISS. If you have a computer network around the shop then just put up the schedule and...

oh, also you can try the data sheet for the specific servo model. Contact either the manufacturer or any other supplier, google search etc, but then again it depends on the length of the pulse input...

I'm thinking a caliper and some trial and error to get your best fit there, the gear pitch and ratio was probably specific to the old software (if it came with the router, I'm assuming it did)...

yeah, definitely go with a dial test indicator, and as with any new tool (assuming you don't already have one) don't get the cheap-o. Make sure it's calibrated, too. And be gentle with those...

Instead of a syringe-type dispensation of the paste, why not build a mini-stencil with a simple solenoid to move a little squeegee? You'd need a syringe to dispense more solder paste onto the...

This is a problem with the tool changer laser on a rxp500 from roeders, but I can't imagine it's much different than on any other machine with a laser component in the tool changer. Does anyone have...