Oh, I didn't realize that. You buy the Pixelmator and you own it. With Photoshop, you pay a subscription forever. But I think there is a basic version of Photoshop you can buy.
Type: Posts; User: davida1234
Oh, I didn't realize that. You buy the Pixelmator and you own it. With Photoshop, you pay a subscription forever. But I think there is a basic version of Photoshop you can buy.
Hi Peter, I use an app called Pixelmator Pro for the graphics but you can do the same with Photoshop as well.
In a nut shell, you create different layers which are stacked on top of each other.
...
I have a set of 23 sized ClearPath servos so I will use them.
For steppers, you can use larger pulleys for higher speeds.
Servo installed.
505390
505392
And the second one.
505388
Install first brace.
505386
Install brace bracket.
505378
Installed drive.
505376
Place ball screw drive onto the carriage.
505374
Rotating ball nut drives.
As the ball screw does not rotate, a 1204 size is used.
Motor size: Nema 23
Lead: 4mm per revolution
Speed: 157 inch/minute @ 1,000 RPM
Dynamic/static rating: about...
Gantry installed.
505356
And the rear bumper stops / ball screw supports.
505354
Install the front bumper stops / ball screw clamps.
505350
505352
And the gantry beam.
505348
The Y/A carriages.
505346
Machine frame is finished.
Thread continues with the design for the Y/A and the X/Z axis.
Install linear rails to the top profile.
505344
.
This concludes the assembly of the machine frame.
It can accommodate different personal designs for the gantry and the Z-axis
and is available for purchase as a complete set as shown on...
And finally, slide the splash screens into place.
Color added to splash screens for clarification.
Frame is shown from the back
505296
505298
Install splash screen guides.
505294
Repeat all steps for the other side of the stringers.
505290
Thanks Peter. Much appreciated....
And finally, install the vibration dampers.
505226
Side plate locks everything in place.
505224
Next is the installation of the side plate.
505222
Top profile should be level but check anyway.
505220
And align with the front face of the upright.
505218
Slide top profile over the braces.
505216
Repeat on remaining stringers.
505034
505036
505038
Install brackets on both sides of the upright.
505032
Slide the profile down between the side plates with the notch facing toward the pan.
(Front side plate omitted for clarification.)
504996
504998
The upright profile has a notch at the bottom.
504994