Search:

HI ALL HERE,

I have drawing a circle array (circle hole inside circle pocket) by Aspire 4.05, also i have checked the simulation of 2 tool paths works, it is looks arranged and the holes is in...

ger21, can u help me how to set the pulse inside software if the microstep on the driver have set on 51200 pulse/rev depend on my gear teeth 14 and module 2.

thank you

yes, i see that, i set the microstep dip on 51200 pulse/rev and set the pulses in software on : 582.500 n/mm, i try it as test and the movement of motors and software looks a little bit matched...

Its a built in software came with the controller all made by china company named :fangling http://en.flcnc.com/cp/html/?5.html , inside software we can only set the X and y pulses xxx.xxx n/mm, the...

[QUOTE=Louis_Cannell;1839852]I am very new at this so can offer little help.

for torque it is not a problem, but i don`t know how to set the drivers steps of motors and controller pulses to make...

no help!

Hi guys,

I start converting a chines portable cnc cutting machine with fangling F2100b controller http://en.flcnc.com/ to a gantry design,
i use two stepper motors 1600/oz to drive the x axis...

Note : i didn't use any resistors inside the connections between the driver and controller as wantai site guide said.
You can check this http://www.wantmotor.com/ProductsView.asp?id=257&pid=82

The driver is set on 3.32amp
the motor amp rate is 3 amp/ 6.3 volt

Hi guys,

I have cncusb mk1 chines copy and i connect it as you see in the attached photos, its turn on well when i using the jogging but the stepper motor temperature increasing with short time...

No replays

Ok, Can anyone give me joystick program & circuit to drive a stepper motors.
somebody speaking about joystick32.ocx
another persons speaking about joycon program
also another one...

Hi,

Hw I can build lathe 3 axises and drive it with mach3 ?
Can anyone guide me in this project ?
I not need to the mechanical parts building instructions of lathe ,but i need to a schematic...