Thanks for your reply. I have done those checks on the tool release and it all works fine. I have all the manuals, tool changer and vacuum bed [emoji1303].
Today I managed to get it to run the F...
Type: Posts; User: CPH1
Thanks for your reply. I have done those checks on the tool release and it all works fine. I have all the manuals, tool changer and vacuum bed [emoji1303].
Today I managed to get it to run the F...
Btw were is the solenoid?
Also I have checked the controller and it gives this error. https://uploads.tapatalk-cdn.com/20190916/95a686978962c846e78ddb83b8fca78f.jpg
Sent from my iPhone using...
Thanks for all you help so far. I will try and take a video when I get a few mins.
Sent from my iPhone using Tapatalk
The air is only coming down from the taper.
Sent from my iPhone using Tapatalk
That’s interesting because it doesn’t. It starts when the spindle try’s to start on warm up but then also stops. So basically when doing the warm up process for 10 mins the spindle looks like it...
It’s no bother I had just wondered if it was a link to the reason why the spindle wasn’t starting.
Sent from my iPhone using Tapatalk
Ok but should it run air all the time even when it’s off or should it not be controlled via a solenoid
Sent from my iPhone using Tapatalk
https://uploads.tapatalk-cdn.com/20190913/1f0e9dcd979ad3e6c02b8a345ebf722d.jpg
Sent from my iPhone using Tapatalk
Thanks for your reply. The air leak I can hear and feel is coming from the chuck. If I put my hand around the chuck I can feel it. Is this to be expected?
Sent from my iPhone using Tapatalk
Hi everyone. I’m new to the forum so not sure if this is the right place to post this.
I have a problem. I have had an AXYZ router in storage for just over year and have only just got round to...