Search:

If you want to see what material remains than you will need to install and run vericut.

YouTube - vericut

Your part looks like the pocket corners are cleaned out are you running the...

YouTube - workpeice.avi

not sure if your verison of pro has auto workpiece so I made it this way.

This shows whats been removed from the slot.

This site has some potential to be a very usefull resource if they keep it up. Check it out.

Welcome to LearningExchange

About Milling NC Sequences
To access Mill type NC sequences, you must be in a Mill or Mill/Turn workcell. The following NC sequence types are available:
● Face—Facing down the workpiece.
● ...

YouTube - dimensoning.avi

please verify that your config pro options are set correctly in the new drawing before you dimension anything

I hate when Pro does that. did your new drawing have the correct number of decimals?

Into the Value box

ok so as i understand config options once you have them set and saved everything you create afterwards will be how you want it and everything before the change will not update. I do think you should...

change the drop down from current session to the other option
and uncheck the show only options loaded from file that should unhide the rest

im running WF 5. can you put up a pic of what yours does look like

Try using the insert menu from the top


INSERT
MANUFACTURING GEOMETRY
MILL VOLUME



then insert a extrude

remember to save your changes

In the tools menu options you can change the default_dec_places value to 3 that should make it do what you want.

I use a volume milling sequence to rough counter bores out then a surface mill sequence (cut lines, closed loops) and a helical path to finish.

you could sketch your entry. Our try useing a diffrent sequence such as volume milling.

I would recomend using a surface mill sequence with cut lines. you could set your step over to a large value such as 30% cutter diam and then allow the scallop height value to control the actual...