Hello Rai,
The varied responses indicate that you could have benefitted by adding some clarification (responses) to the guys who offered suggestions.
All of the folks who help, like to get some...
Type: Posts; User: jimwymz
Hello Rai,
The varied responses indicate that you could have benefitted by adding some clarification (responses) to the guys who offered suggestions.
All of the folks who help, like to get some...
mohammadali ,
Be Carefull!! You can lose Data that the battery is there to Keep!!
The Battery is there to backup some type of Memory, by holding the small amount of current needed to keep...
Mike,
Is your controller a Fanuc 6 MB?
If it is use the G-codes noted in my prior post for Machine center, not Lathe!
BTW if you have a manual and can copy / scan / e-mail the Table of...
Mike,
Fanuc Controlled Machining Centers control Feed in two ways, by G-Code.
1.) G94 Feed per Minute (This is usually the Default){see notes below}
or
2.) G95 Feed per Rotation (This Not...
Wiseco,
Many Posts have a "Canned Set of output Code" at "Beginning of Tool",
Perhaps yours always assumes That all Lathe work Starts at the Finished Face.
(as several here have suggested... I...