Search:

I have an SL15 Mori with Yasnac LX3 control and the x axis has the minus on the the top of the stroke and plus on the bottom. This is the reverse of most other machines and makes programing a problem...

I have the same model Takasawa and lost the PC parameters. Do you have a copy and if so, can you share them with me? I only need the PC parameters from number 100 up.
Thank you,
Hal in Arizona USA

Mike:
I have a Takasawa TS15 and I need the pc parameters. Did you get your machine running? Can you share the PC parameters with me?
Thnaks,
Hal in Arizona

Fernando:
I also have a Takisawa lathe with Fanuc 3T and I have all the parameters except the pc parameters that configure the turret. can you pass the pc parameters on to me? I need from parameter...

I also have a Takisawa lathe with Fanuc 3T and I have all the parameters except the pc parameters that configure the turret. Were you succesfull in restoring your machine? if so, can you pass the pc...

I have a Takisawa turning center with Fanuc 3T control that has a turret indexing problem.
Does anybody know of any good field repair people in western AZ, or Las Vegas area that will make "house...

I saw this old post and was hoping someone knew of a service person in Southwest (Az or Nevada) that makes house calls.

Do you still have any of these parts? I need a Fanuc A40L-0001-0191 resistor and saw your old post
Thanks, H. Lockett

Can anyone recomend a Fanuc tech that services south western Arizona? I have a Takisawa VMC that has a problem with the spindle drive or voltage. I am about 20 miles from both Phoenix and Las Vegas...