I have experiece with this issue, the older of the SG series T42 conquest lathes had the pressure switch wired in series with the float. The easy way to check yours is go to the PMC status page in...
Type: Posts; User: tleck
I have experiece with this issue, the older of the SG series T42 conquest lathes had the pressure switch wired in series with the float. The easy way to check yours is go to the PMC status page in...
The dual spindle lathe that i am installing the spindle orient on, has two spindles driven by a common drive motor. The spindles are driven via a jackshaft assm. The issue that I have run into is...
what is involved with installing spindle orient on an olofsson dual spindle vertical lathe with a fanuc 15 series A control unit, D1 configuration? the drive of the spindles has been setup with...