Search:

If you dont mind, please send to my email, [email protected]

Thanks you verymuch.

try this circuit, last time i use for control torch my plasma .

dear Gabor,

following the instruction manual, this condition not indicate have alarm, but have incomplete initialization when start up, something like waiting some signal for make the unit in...

Dear gbezzegi,

sorry for late reply, on unit show b1 not 61. On mr-j2 setup software not have alarm.:drowning:

Dear all,
mazak QT200 all condition ok ( x,z axis and spindle are normal ) except the turret unit can not rotate when give command, on mrj2-100-ct unit led show B1, as far as i know when normal...

Dear C-4, alarm 401 mean servo amp is not turned on or turned off during operation, i think your problem on cable connection between servo amp and main cpu or have some short circuit on your machine...

Hai ashro, you can try to change parameter P19 ,P19= 0, data input in mm and P19=1, data input in inch, hope can help you..

Dear all,
my problem has solved, i try to clone this OK harddrive using freeware from internet. thank all.

I have hitachi seiki NRIII with Seicos lambda 10 L, this problem can't start up now, after check i found the hardrive fail ( i try to change with other hardrive with same machine., and this machine...

Sound you machine is cnc Milling machine ( X,Y,Z axis), but in my machine (cnc lathe)
#700 = X axis, #701= Z axis, so if you can trace where parameter for Y axis, you can try to change to 999999...

SVP hardware or sofware condition were no met, which made it impossible to start up the SVP, try to check SVP board mounted, encoder connection all axis.
hope can help you.

HURCO VM1 for ATC unit still using air system, have 2 air cylinder for 0-60 degres and or 180 degres, so i think your machine have problem on 60 degres rotates, sound like your linear gear on atc...

Alarm 31, the mean spindle motor constrained, defective motor speed reversion signal/signal cable, so you can try to check conection cable from Spindle amp to motor ( signal cable )
good luck..

I'm 33...http://www.cnczone.com/forums/images/smilies/iamwithstupid.gif

Off The machine and then Power on Machine with pressed DEL+Reset

Im sure THe alarm 911 gone, after that select MDI and change PWE to 1
and key in all data parameter, but first time you must key...

you must check all wiring/connection on Z axis area ( Spindle Wire or something ), I think you have some wire crack and short to ground when z axis moving, this problem also happen to last time, I...

What M/C control you use? for reset M/C you mut clear all data ( M/C param, User Param, Tool condition, etc ) after that you can fill in parameter after reset you m/c...goood luck

My QT-200 machine have alarm AL-20 on Turret controller (MR-J2_100CT), I think this encoder problem (OSA14), can I replace encoder only on servomotor (HC-SF-102) ? somebody can help ..me

find first the motor model and browse on mitsubishi site.