Search:

If your cutting any thin sections clean through, the Corian can warp.
I make harmonicas from Corian and some colors are unusable.
I know that sounds weird but darker colors get allot hotter than...

Thanks for the reply Jim. Here is a better picture of what Im trying to do. In the first pic on the left I want a profile like the blue and green harp but more of a gradual slope up. But still very...

No, not just yet. But they are pretty close to the ones in the picture. The front will be more open for better sound projection. And the side with the holes will have a narrower profile.

I know you were not try to say Im dumb. I was just trying to be funny. Sorry.

Sorry, I forgot to say I just need the covers . I make the combs (body) myself.

Just the front edge thats open is rolled. The rest must be cut and dead flat.
I would rather do them myself if possible.

Where would I research this further? I actually want to make many thousands of these. Thanks

Check out joewoodworker.com A wealth of info on the subject.

Can someone please tell me what would be the most cost effective way to make my own harmonica coverplates? The metal is 0.025 thick. I have been to several machine shops and they have been no help....

Im not spraying brake cleaner on my mill. Im not THAT stupid. Just a small test area.
DOH!! I know better. Ive been a painter for 30 years.

Yea! It does. Just tried it on mine. Use a citrus cleaner.

Im almost positive brake cleaner will strip the paint.

You will never do it with a compressor , venturi type affair. Too much surface area.

What are you cutting out? What edge cut quality do you need?

Go to joewoodworker.com Anything you want to know about vacuum work holding is there.

Thanks for the reply, I had it lying around and its double shaft, Just what I need for my z axis.Tired of moving it by twisting the coupling with my fingers.

Blues. The ONLY music

Oh! I almost forgot. i would like to wire them bi polar parallel for max torque.

Do you think a new motor wiring data base category should be established?
This would be totally at the discretion of the site itself obviously, as I dont know how this would the effect the volume of...

I have searched the net to no avail for the wiring for a superior electric slo syn stepper mo-63. This should be easy. The connector has the wires in the following order...

Mitey bite is the only way to go. They rock.

Never mind. I called Gecko and they said " Dont do that, It can blow the drive" So now we all know.

Anyone!!!

Can someone tell me if it can hurt my g-201s if I crank the handwheels fast when manual machining. I noticed the leds pulse as I do it. I blew a drive a year ago and was wondering if this is what did...

Been using the thing for 4 years and would have known that had I read the docs.When in doubt read the instructions.

Anyone?

Its alot faster to move the handwheel a couple of hundreths. Anyone know if I can do the switch thing or not?

No,I dont have home switches and i have to take a real acurate measurement from the cutter to the point im starting with a caliper.

Im cutting a repetative part and was wondering if its ok to put some disable switches after the drives going to the motors.I want to do this because i doubt if its good for the drives to keep turning...

Absolutely!!!!!!!!! And its driving me up the wall.Been a member for 4 years and most of the time when i try to log in i get a message saying i dont have permission to access that page.Whats up!! I...