I am trying to get my VFD to work on my lathe. It is labled as a VEKKO. I am pretty sure I wired it wrong.
I have all my function codes programmed in.
Right now my potentiometer does move the...
Type: Posts; User: kevbo22
I am trying to get my VFD to work on my lathe. It is labled as a VEKKO. I am pretty sure I wired it wrong.
I have all my function codes programmed in.
Right now my potentiometer does move the...
Hey everyone
I recieved some goodies in the mail today. I got the new tool holder, but I also recieved a new generation model haimer and tool holder for that I purchased.
I quickly went...
I do tighten the drawbar, but not so tight that I need to tap the drawbar to release the haimer out of the spindle.
To day I ran a indicator in the spindle, it was fine.. maybe 2 tenths out.
I put in the r8 and the haimer tool holder and ran the indicator in the tool holder bore. a thou of runout.
I ordered...
Excellent share! I will read the pdf later tonight, thank you
I do not have a power drawbar. I will however be getting one in a few months. I hope I figure out the issue.
I tried this with a new r8 collet today. I still am having the same issues. I will...
Ya, im right there with ya. I am about ready to give up on it as well.
No, I do not have any grease or anti seize in the spindle. I have also made sure that I have no left over chips in it. I can check to see if the runout is the same. I only have ever checked it the...
Ya i did do this. I attached a picture of that in my first post. Still didnt work however.
Thank you, should be a good start!
- - - Updated - - -
Thank you, should be a good start!
I got my self a haimer sensor. I have been trying to dial it in. Not a friendly task.
I worked on it for some time before I started learning how to do it. I can dial it quite quickly now. I dial...
Fusion 360 to start with.
Just as the title says, I would like to learn how to make my own post processors. A decent text book would be nice. Does anyone have a recommendation for me?
Thank you