I shorted one of the wires on stepper,the 6560 went up in smoke.
Now I cannot use other axis.do I have to put new chip in so I can use axis?do you
Burn other thing out too?
Type: Posts; User: leo segar
I shorted one of the wires on stepper,the 6560 went up in smoke.
Now I cannot use other axis.do I have to put new chip in so I can use axis?do you
Burn other thing out too?
putting new up to date boards in from Mechatronics
i am putting a new 3 axis Mechatronics 3 axis micro stepper motor driver board in it.i have not received it yet.
i will use Mach 3 software,maybe.
stepper motors a good,i talked to light machine...
I do. Not have board out yet, i will
Take board out and take pic of stepper motor. I will check interface board too.
Thank u
my tmc 1000 y axis quit working.the monitor shows that it is moving but it is not.
the stepper motor is a 4 wire system,does any body know what color wires goes where?
LEO's answer
i had the same trouble,i was also having my tmc looseing my positioning while it was running.i found out when it was going in rapid that is were it was messing up.like just...