How's everyone doing? I would like to reach out and ask for advice and opinions about the purchase of a new plasma table. We currently have a Spidercut CNC table that isn't meeting our needs and...
Type: Posts; User: CBlom
How's everyone doing? I would like to reach out and ask for advice and opinions about the purchase of a new plasma table. We currently have a Spidercut CNC table that isn't meeting our needs and...
Thank you for the reply.
How's everyone doing? I have a question(s)
We use Coreldraw to Sheetcam to Mach3. When we draw what we want in Coreldraw and import it to Sheetcam, Sheetcam adds extra nodes and the drawing...
Thanks for the help Willy.
Good morning Willy, thanks for the response. We are using Coreldrawx8 and when we made a circle in a circle (outer circle was 8"x8" Inside circle was 7"x7" So a donut) and exported it in SVG to...
I tried SVG and that's going to take some work to figure out. As for CV, it's on. The nodes are at the 12 - 9 - 6 - 3 o'clock position and if I try to remove the nodes obviously the circle becomes...
Thanks for the help Willy. I'll give it a go. When I run the simulation in sheetcam the imaginary tool in sheetcam doesn't stop. When I run it through Mach3 the table stops at the cardinal points (...
Question; I have a 4'x4' plasma table running on Mach3. We are setting the table up and trying to get to as close as perfect as possible before we start cutting metal. In Correl draw we made a 10"...