All,
Thanks for your feedback and help in deciding which direction to go. I will go with the AXBB-E configuration.
Adrian
- - - Updated - - -
All,
Type: Posts; User: awilcox
All,
Thanks for your feedback and help in deciding which direction to go. I will go with the AXBB-E configuration.
Adrian
- - - Updated - - -
All,
I am upgrading my cnc controller and drivers and I am seeking advice.
My current setup has:
- C10 bob
- OMS mh110 drivers
- Linux software
I am switching to:
- DM556D drivers
- UCCNC...
Mike,
I am considering upgrading to a spindle. Care to share your thoughts and experiences with your spindle?
Adrian
Thanks, can't be too careful.
Adrian
I sent an email yesterday but I haven't heard from them. I have a mm so I can check continuity. When you say gnd to com, which gnd are you referring to (5v input or next to enable input)?
Adrian
Jay,
Thanks for the helpful information.
The rev 7 bob doesn't have a jumper fror the 5v/gnd function. I am assuming if I connect to this terminal and I do not send a 5v signal, then it defaults...
Before I fry a second driver I thought I would ask the group. How do you wire terminal 12 on the g251? The documentation states logic ground and I am slightly confused as to what it means. I have a...
Mike,
Thanks! I will check my connections tonight.
Adrian
Mike,
I am experiencing the same problem with my z-axis. I have a Gecko drive (gel210a) on this axis. Any answers or solutions yet?
Adrian
I am having trouble powering my oms drives in the controller. I have the c10, rev 7 bob, c2 mini pwr supply and mh10 oms drives.
Frist I connected the 5v from the c2 to the bob and 5v from the cs...
I am another noob in desperate need of help. I purchased motors for my 3-axis machine (under construction) and I need help determing which controller and ps to use. The motors are rated at 425 oz-in,...
What a diy machine!!!
I read your documentation and I was a little confused as to which parts of the frame were welded. As I understand it, small components (brackets, angle, flanges and plates)...