Search:

https://drive.google.com/file/d/1skerBXB4JViFee9Nfk1LyF5cy_wzBpN-/view?usp=sharing

Does that work?

First of all, I'm wondering why there is no Samsung section in the machine type forums. But my main question is, how do you enable and disable the stack lights on the machine? We have a few Samsung...

Anyone know where I can get a replacement box for my 81pc gage block set? I bought a set from SPI and, while the blocks are fine, grade B or economy, the box is junk. Its a wooden box with a plastic...

Yeah, what he said.

Sent from my Droid using Tapatalk

I've come to the conclusion that this Guy didn't come here for advice or guidance but just to argue with people who know how to program.

Sent from my Droid using Tapatalk

I'm not sure what kind of controller you're using, ie software, but it should look something like this, ignoring the correct approach of tool to part, taking only .010 cuts and not using a canned...

What kind of machine?

Sent from my Droid using Tapatalk

Sorry but none of this makes any sense to me. That looks like alot of nonsense to me. There is a book by Peter smid on cnc programming which is pretty good.

Sent from my Droid using Tapatalk

Got a pic or a sketch of what you want? You're way off on your g code and I'd be glad to help. After u see the program properly written you'll probably start to understand it.

Sent from my Droid...

I find that most lathe parts are way easier to program at the control than on a cad can program. I've only used mastercam for mills or to determine points difficult to trig out.

Sent from my Droid...

We have a tl1 and it holds size pretty well. I was surprised at its accuracy as I too found it hard to believe it could hold size taking the tools off and on again. As long as everything is tight and...

Yeah, one of our machines is way off in what could be considered "Y" as well as x so we usually indicate them in on that one. I always use f2 on the others though and I suspect they would be...

Well, you have to be in hand jog or nothing happens, but when you do get it to work, make sure your tool actually goes to center. It uses a number in parameters which can be off a bit if anything has...

Yeah, I drill through it with a 1.5" spade drill, face & turn it, bore it, and on the other side I face to length, bore, thread and cut a face groove from about an inch or so below the OD, to...

I can get you a copy of the manual if you still need it, not a hardcopy, but as a file.

As far as drip feeding on the dynapath, it's pretty simple, I've only done it a couple times, but it's...

I looked at my program today and I was mistaken, the part is 12.5" in dia. I approach to face and exit the od cut at 12.6". I'm not sure what manufacturer the tool is, but it is unaltered. The number...

G0 X.5 Z.1 M08;
G71 P5 Q6 D.05 F.01;
N5 X1.63;
Z.05 G41;
G1 X1.5 Z-.015;
Z-2.0;
X.5;
N6 X.45 G40;

In my shop we regularly run 11, 11.25, and 12" dia. aluminum in our sl20.